FIRE Pistons
Replace your Damaged or Low Flowing regulator piston. These pistons are higher flow which will allow you to run a lower operating pressure*. 6061 anodized pistons will stand the test of time.
RED FIRE Piston works with Inception Designs v1, v2. Recommended for v1 & v2 to buy the DFI Reg seat and fully rebuild your Reg. The v3 regs with the new spring disk will be less of a potential uplift.
BLUE Fire Pistons work with WGP HPRs, Empire Resurrection & Sniper, and MacDeV Gladiator 2
Recommendation:
- DFI Reg Seats for WGP, Empire, and ID v1 and v2 (purchase separately)
- Lube DOW 33 light or Slickoleum (O-rings are petroleum safe)
- Use a Maco line hose to install piston and remove piston. DO NOT USE an allen key or metal tool to push piston out by stem you will damage it.
- Rubber cap tool to aid in piston removal. (put cap on an 1/8" allen key to push piston out).
- WGP Regs Belville spring are good and can be reused
- Empire and ID v1-v2 and some v3 Belville springs need to be replaced with kit springs.
Kit includes:
- FIRE Piston (ID or WGP)
- 8 Belville SS springs
- 2 super high quality o-rings (Piston -113 & Piston stem -008)
- Spring Chart
Spring configs:
- WGP ()()()( Try stock springs first
- Res and Sniper )()()()(, )()()((, ()()()(
- MacDev )()()()(
- Inception )()()()(
- You can Try different configs at your own risk
*Lower operating pressure will vary depending on setup, paint quality and barrel paint match.